Effect of the alkaline cation size on the conductivity in gel polymer electrolytes and their influence on photo electrochemical solar cells

Literature Information

Publication Date 2016-03-16
DOI 10.1039/C6CP00013D
Impact Factor 3.676
Authors

M. Furlani, I. Albinsson, J. L. Ratnasekera, B.-E. Mellander


View Original

Abstract

The nature and concentration of cationic species in the electrolyte exert a profound influence on the efficiency of nanocrystalline dye-sensitized solar cells (DSSCs). A series of DSSCs based on gel electrolytes containing five alkali iodide salts (LiI, NaI, KI, RbI and CsI) and polyacrylonitrile with plasticizers were fabricated and studied, in order to investigate the dependence of solar cell performance on the cation size. The ionic conductivity of electrolytes with relatively large cations, K+, Rb+ and Cs+, was higher and essentially constant, while for the electrolytes containing the two smaller cations, Na+ and Li+, the conductivity values were lower. The temperature dependence of conductivity in this series appears to follow the Vogel–Tamman–Fulcher equation. The sample containing the smallest cation shows the lowest conductivity and the highest activation energy of ∼36.5 meV, while K+, Rb+ and Cs+ containing samples show an activation energy of ∼30.5 meV. DSSCs based on the gel electrolyte and a TiO2 double layer with the N719 dye exhibited an enhancement in the open circuit voltage with increasing cation size. This can be attributed to the decrease in the recombination rate of electrons and to the conduction band shift resulting from cation adsorption by TiO2. The maximum efficiency value, 3.48%, was obtained for the CsI containing cell. The efficiencies shown in this study are lower compared to values reported in the literature, and this can be attributed to the use of a single salt and the absence of other additives, since the focus of the present study was to analyze the cation effect. The highest short circuit current density of 9.43 mA cm−2 was shown by the RbI containing cell. The enhancement of the solar cell performance with increasing size of the cation is discussed in terms of the effect of the cations on the TiO2 anode and ion transport in the electrolyte. In liquid electrolyte based DSSCs, the short circuit current density has been reported to decrease with the increasing size of the cation. However, in this work, it follows an opposite trend highlighting a major difference between liquid and quasi-solid electrolytes on the solar cell performance.

Related Literature

Palladium supported on a magnetic microgel: an efficient and recyclable catalyst for Suzuki and Heck reactions in water

Jianhua Yang, Dongfang Wang, Wendong Liu, Xi Zhang, Fengling Bian, Wei Yu

2013-09-18 Paper

DOI: 10.1039/C3GC40941D

Life cycle assessment of surfactants: the case of an alkyl polyglucoside used as a self emulsifier in cosmetics

Jérôme Guilbot, Sébastien Kerverdo, Alain Milius, Rémi Escola, Fredrik Pomrehn

2013-10-04 Paper

DOI: 10.1039/C3GC41338A

Reclamation and reuse of ionic liquids from silica-based ionogels using spontaneous water-driven separation

Ariel I. Horowitz, Yushi Wang, Matthew J. Panzer

2013-09-27 Paper

DOI: 10.1039/C3GC41661E

Back cover

Cover

DOI: 10.1039/C3GC90051G

Ru-based magnetic nanoparticles (MNP) for succinic acid synthesis from levulinic acid

Iunia Podolean, Victor Kuncser, Nicoleta Gheorghe, Dan Macovei, Vasile I. Parvulescu, Simona M. Coman

2013-08-14 Paper

DOI: 10.1039/C3GC41120F

Bridging racemic lactate esters with stereoselective polylactic acid using commercial lipase catalysis

Pieter Van Wouwe, Michiel Dusselier, Aurelie Basiç, Bert F. Sels

2013-08-14 Paper

DOI: 10.1039/C3GC41457D

Contents list

Front/Back Matter

DOI: 10.1039/C3GC90045B

Continuous flow nanocatalysis: reaction pathways in the conversion of levulinic acid to valuable chemicals

J. Angel Menéndez, Antonio A. Romero, Elena Serrano, Javier Garcia-Martinez, Rafael Luque

2013-07-31 Paper

DOI: 10.1039/C3GC41022F

Robust porphyrincatalysts immobilized on biogenous iron oxide for the repetitive conversions of epoxides and CO2 into cyclic carbonates

Tadashi Ema, Yuki Miyazaki, Tomoya Taniguchi, Jun Takada

2013-07-18 Paper

DOI: 10.1039/C3GC41055B

A new generation of aprotic yet Brønsted acidic imidazolium salts: effect of ester/amide groups in the C-2, C-4 and C-5 on antimicrobial toxicity and biodegradation

Rohitkumar G. Gore, Lauren Myles, Marcel Spulak, Ian Beadham, Teresa M. Garcia, Stephen J. Connon, Nicholas Gathergood

2013-09-05 Paper

DOI: 10.1039/C3GC40992A

You might also like

155412-88-71-(3-Aminophenyl)-3-...
Compound Q&A

How should waste containing 1-(D-Ribofuranosyl)-1,4-dihydro-3-pyridinecarboxamide (CAS: 19132-12-8) be handled?

Waste containing 1-(D-Ribofuranosyl)-1,4-dihydro-3-pyridinecarboxamide (CAS: 191...

19132-12-81-(D-Ribofuranosyl)-...
Compound Q&A

What regulatory guidelines apply to 2-Methyl-2-propanyl 3-bromo-3-(hydroxymethyl)-1-azetidinecarboxylate (CAS: 2007919-81-3)?

2-Methyl-2-propanyl 3-bromo-3-(hydroxymethyl)-1-azetidinecarboxylate (CAS: 20079...

2007919-81-32-Methyl-2-propanyl ...
Compound Q&A

What is N-(4-Chloro-2-pyridinyl)acetamide (CAS: 245056-66-0)?

N-(4-Chloro-2-pyridinyl)acetamide (CAS: 245056-66-0) is a chemical compound with...

245056-66-0N-(4-Chloro-2-pyridi...
Compound Q&A

What is 5-Chloro-2-hydroxybenzoic acid (CAS: 321-14-2)?

5-Chloro-2-hydroxybenzoic acid, also known as 5-chlorosalicylic acid, is an arom...

321-14-25-Chloro-2-hydroxybe...
Compound Q&A

What precautions should be taken when handling 1,1-Dichloro-1-fluoroethane (CAS: 1717-00-6)?

When handling 1,1-Dichloro-1-fluoroethane (CAS: 1717-00-6), it is important to u...

1717-00-61,1-Dichloro-1-fluor...
Compound Q&A

What are the physical and chemical properties of Fmoc-(2S,3R)-3-phenylpyrrolidine-2-carboxylic acid (CAS: 281655-32-1)?

Fmoc-(2S,3R)-3-phenylpyrrolidine-2-carboxylic acid is a white crystalline solid ...

281655-32-1Fmoc-(2S,3R)-3-pheny...
Compound Q&A

What are the main uses of 4-Amino-5-bromo-2-pyridinecarboxylic acid (CAS: 1363381-01-4)?

4-Amino-5-bromo-2-pyridinecarboxylic acid is primarily used as a precursor in th...

1363381-01-44-Amino-5-bromo-2-py...
1007881-98-2(S)-tert-butyl 2-((2...
Compound Q&A

What precautions should be taken when handling 8-bromo-2,2-dimethyl-3,4-dihydro-2H-1,4-benzoxazin-3-one (CAS: 688363-73-7)?

When handling 8-bromo-2,2-dimethyl-3,4-dihydro-2H-1,4-benzoxazin-3-one, use prop...

688363-73-78-bromo-2,2-dimethyl...

Source Journal

Physical Chemistry Chemical Physics

Physical Chemistry Chemical Physics
CiteScore: 5.5
Self-citation Rate: 10.3%
Articles per Year: 3036

Physical Chemistry Chemical Physics (PCCP) is an international journal co-owned by 19 physical chemistry and physics societies from around the world. This journal publishes original, cutting-edge research in physical chemistry, chemical physics and biophysical chemistry. To be suitable for publication in PCCP, articles must include significant innovation and/or insight into physical chemistry; this is the most important criterion that reviewers and Editors will judge against when evaluating submissions. The journal has a broad scope and welcomes contributions spanning experiment, theory, computation and data science. Topical coverage includes spectroscopy, dynamics, kinetics, statistical mechanics, thermodynamics, electrochemistry, catalysis, surface science, quantum mechanics, quantum computing and machine learning. Interdisciplinary research areas such as polymers and soft matter, materials, nanoscience, energy, surfaces/interfaces, and biophysical chemistry are welcomed if they demonstrate significant innovation and/or insight into physical chemistry. Joined experimental/theoretical studies are particularly appreciated when complementary and based on up-to-date approaches.

Recommended Compounds

Recommended Suppliers

Disclaimer
This page provides academic journal information for reference and research purposes only. We are not affiliated with any journal publishers and do not handle publication submissions. For publication-related inquiries, please contact the respective journal publishers directly.
If you notice any inaccuracies in the information displayed, please contact us at support@chemtradehub.com. We will promptly review and address your concerns.