Influence of humidity and iron(iii) on photodegradation of atmospheric secondary organic aerosol particles
Literature Information
Kurtis T. Malecha, Markus Ammann, Sergey A. Nizkorodov
The absorption of solar actinic radiation by atmospheric secondary organic aerosol (SOA) particles drives condensed-phase photochemical processes, which lead to particle mass loss by the production of CO, CO2, hydrocarbons, and various oxygenated volatile organic compounds (OVOCs). We examined the influence of relative humidity (RH) and Fe(III) content on the OVOC release and subsequent mass loss from secondary organic aerosol material (SOM) during UV irradiation. The samples were generated in a flow tube reactor from the oxidation of D-limonene by ozone. The SOM was collected with a Micro Orifice Uniform Deposit Impactor (MOUDI) on CaF2 windows. To selected samples, a variable amount of FeCl3 was added before irradiation. The resulting SOM samples, with or without added FeCl3, were irradiated with a 305 nm light-emitting diode and the release of several OVOCs, including acetic acid, acetone, formic acid and acetaldehyde, was measured with a Proton Transfer Reaction Time-of-Flight Mass Spectrometer (PTR-ToF-MS). The release of OVOCs from photodegradation of SOM at typical ambient mid-values of RH (30–70%) was 2–4 times higher than under dry conditions. The release of OVOCs was slightly enhanced in the presence of low concentrations of iron (0.04 Fe molar ratio) but it was suppressed at higher concentrations (0.50 Fe molar ratio) of iron indicating the existence of a complicated radical chemistry driving the photodegradation of SOM. Our findings suggest that the presence of iron in atmospheric aerosol particles will either increase or decrease release of OVOCs due to the photodegradation of SOM depending on whether the relative iron concentration is low or high, respectively. At atmospherically relevant RH conditions, the expected fractional mass loss induced by these photochemical processes from limonene SOA particles would be between 2 and 4% of particle mass per hour. Therefore, photodegradation is an important aging mechanism for this type of SOA.
Related Literature
Two-dimensional SPdAZ2 (A = Si, Ge; Z = N, P, As) monolayers with an intrinsic electric field for high-performance photocatalysis
Zhen Gao, Yao He, Kai Xiong
DOI: 10.1039/D3CP04936A
Development of a QM/MM(ABEEM) method for the deprotonation of neutral and cation radicals in the G-tetrad and GGX(8-oxo-G) tetrad
Yue Wang, Linlin Liu, Yue Gao, Jiayue Zhao, Cui Liu, Lidong Gong, Zhongzhi Yang
DOI: 10.1039/D3CP04357F
Site planning and selection of hydrogen refueling stations considering the life cycle and demand uncertainty
Xunpeng Qin, Cenglin Yao, Mao Ni, Jun Zhou, Ling Liu, Wenyi Li, Wenlong Yang
DOI: 10.1039/D3SE00897E
Research on structural strengthening technology for regenerative denitration catalysts
Dongliang Ji, Dongxue Jiang, Yang Li, Huan Zhang, Haiyun Zhou, Zhaoqin Huang, Jianzhong Zhu
DOI: 10.1039/D3CP04214F
An electrospun PVDF-KNN nanofiber based lead-free piezoelectric nanogenerator for mechanical energy scavenging and self-powered force sensing applications
DOI: 10.1039/D3SE00880K
Constructing low-cost and high-strength ultra-low-density proppants based on the modification of activated carbon framework with in situ hydrolyzed silane
Zhen Zeng, Shiqiang Wang, Ermei Liu, Wei Qin, Yang Zhou, Zhenyong Li, Yu Song, Min Xu, Fuli Bian, Xianyan Ren
DOI: 10.1039/D3SE01311A
Modulating CsPbBr3 nanocrystals encapsulated in PCN-224(Zr) for boosting full-spectrum-driven CO2 reduction: S-scheme transfer, photothermal-synergistic effect, and DFT calculations
Yan-He Chen, Jin-Qiu Shen, Xiao-Lu Chen, Luobing Tang, Na Zhang, Jian-Yong Zhang, Zhen-Jiang Liu
DOI: 10.1039/D3SE01029E
Expression of concern: Optimization of a compact layer of TiO2via atomic-layer deposition for high-performance perovskite solar cells
Ahmed Esmail Shalan, Sudhakar Narra, Tomoya Oshikiri, Kosei Ueno, Xu Shi, Hui-Ping Wu, Mahmoud M. Elshanawany, Eric Wei-Guang Diau
DOI: 10.1039/D3SE90087H
Photoelectrochemical conversion of glycerol aqueous solution to value-added chemicals using Bi2Fe4O9 as a photoanode
Bruno L. da Silva, Saulo A. Carminati, Matheus B. C. Souza, Leonardo C. Soares, Claudia Longo, Pablo S. Fernández, Ana F. Nogueira
DOI: 10.1039/D3SE01045G
You might also like
How should waste containing 4-Bromo-3-methyl-2-thiophenecarboxylic acid (CAS: 265652-39-9) be handled?
Waste containing 4-Bromo-3-methyl-2-thiophenecarboxylic acid (CAS: 265652-39-9) ...
What industries use (2S,5S,2'S,5'S)-1,1'-(1,2-Ethanediyl)bis(2,5-dimethylphospholane) (CAS: 136779-26-5)?
(2S,5S,2'S,5'S)-1,1'-(1,2-Ethanediyl)bis(2,5-dimethylphospholane) is primarily u...
What industries use Ethyl 2-(2-bromo-5-fluorophenyl)acetate (CAS: 1214910-61-8)?
Ethyl 2-(2-bromo-5-fluorophenyl)acetate (CAS: 1214910-61-8) is used in the pharm...
How is 4-Methyl-2-benzofuran-1,3-dione (CAS: 4792-30-7) typically synthesized?
4-Methyl-2-benzofuran-1,3-dione (CAS: 4792-30-7) can be synthesized through seve...
What industries use 4,6-Dichloroquinoline-3-carbonitrile (CAS: 936498-04-3)?
4,6-Dichloroquinoline-3-carbonitrile (CAS: 936498-04-3) is used in the pharmaceu...
What are the main uses of Chloro[tris(para-trifluoromethylphenyl)phosphine]gold(I) (CAS: 385815-83-8)?
Chloro[tris(para-trifluoromethylphenyl)phosphine]gold(I) is primarily used in or...
Is 2-Bromo-5-nitrofuran (CAS: 823-73-4) safe?
2-Bromo-5-nitrofuran (CAS: 823-73-4) is generally considered safe when handled w...
How should 5-Bromo-2,3,4-trifluorobenzoic acid (CAS: 212631-85-1) be stored?
5-Bromo-2,3,4-trifluorobenzoic acid should be stored in a cool, dry place away f...
What are the main uses of Zinc bis(aminoacetate) (CAS: 7214-08-6)?
Zinc bis(aminoacetate) (CAS: 7214-08-6) is primarily used in the pharmaceutical ...
How should Adamantan-1-ylmethanol (CAS: 770-71-8) be stored?
Adamantan-1-ylmethanol should be stored in a cool, dry, and well-ventilated plac...
Source Journal
Physical Chemistry Chemical Physics

Physical Chemistry Chemical Physics (PCCP) is an international journal co-owned by 19 physical chemistry and physics societies from around the world. This journal publishes original, cutting-edge research in physical chemistry, chemical physics and biophysical chemistry. To be suitable for publication in PCCP, articles must include significant innovation and/or insight into physical chemistry; this is the most important criterion that reviewers and Editors will judge against when evaluating submissions. The journal has a broad scope and welcomes contributions spanning experiment, theory, computation and data science. Topical coverage includes spectroscopy, dynamics, kinetics, statistical mechanics, thermodynamics, electrochemistry, catalysis, surface science, quantum mechanics, quantum computing and machine learning. Interdisciplinary research areas such as polymers and soft matter, materials, nanoscience, energy, surfaces/interfaces, and biophysical chemistry are welcomed if they demonstrate significant innovation and/or insight into physical chemistry. Joined experimental/theoretical studies are particularly appreciated when complementary and based on up-to-date approaches.











![(2R)-2,7,8-Trimethyl-2-[(4R,8R)-4,8,12-trimethyltridecyl]-6-chromanol structure (2R)-2,7,8-Trimethyl-2-[(4R,8R)-4,8,12-trimethyltridecyl]-6-chromanol structure](https://static.chemtradehub.com/structs/54-/54-28-4-155c.webp)

![2,5-Furandione, dihydro-3-[3-(triethoxysilyl)propyl]- structure 2,5-Furandione, dihydro-3-[3-(triethoxysilyl)propyl]- structure](https://static.chemtradehub.com/structs/936/93642-68-3-3b4b.webp)
![(1S,2R,4S)-1,7,7-Trimethylbicyclo[2.2.1]heptan-2-ol structure (1S,2R,4S)-1,7,7-Trimethylbicyclo[2.2.1]heptan-2-ol structure](https://static.chemtradehub.com/structs/464/464-45-9-f88b.webp)