Large-scale measurement of soil organic carbon using compact near-infrared spectrophotometers: effect of soil sample preparation and the use of local modelling
Literature Information
Celio Pasquini, Emanuelle. M. B. Soares
Compact near-infrared (NIR) spectrophotometers are low-cost instruments that enable rapid, non-destructive and environmentally friendly measurement of soil organic carbon (SOC). However, several aspects, such as soil sample preparation modes or modelling strategies, related to the use of these instruments in large and heterogeneous data sets are yet to be addressed extensively. This work aimed to evaluate the performance of two compact NIR spectrophotometers (NeoSpectra and NanoNIR) to determine SOC content in a large-scale application. Also, it is important to understand the implications of soil sample preparation (soil grinding and drying) and the use of local partial least squares regression (LOCAL-PLSR) on the accuracy of the models built using these instruments. The soil samples of the calibration (n = 320, selected using the Kennard–Stone algorithm) and validation sets (n = 160) were collected from Minas Gerais state (approximately 589 000 km2), Brazil. Three soil sample preparation modes were considered: air-dried and 2 mm sieved samples, air-dried and finely ground samples, and oven-dried and ground samples. Models to determine SOC were developed using the traditional PLSR (GLOBAL-PLSR) and a new approach based on LOCAL-PLSR, and their performance was evaluated using the root mean square error of prediction (RMSEP). The accuracy of the models built using the compact instruments was compared with the accuracy achieved using a bench Vis-NIR spectrophotometer. The NeoSpectra was the best-performing spectrophotometer, showing values of RMSEP, R2 and bias, respectively, between 5.2 and 6.3 g kg−1, 0.522 and 0.645 and −0.08 and −0.594. Significant enhancements in SOC estimation of up to 13% were found when models were calibrated using LOCAL-PLSR and oven-dried and ground soil samples. Our results showed that compact NIR spectrophotometers are a cost-effective alternative to the Vis-NIR spectrophotometers for large-scale SOC measurement. Models built using these instruments were accurate, mainly when LOCAL-PLSR calibration was used together with oven-dried and ground soil samples.
Recommended Journals

Bulletin of the Chemical Society of Japan

Chemical Reviews

Canadian Metallurgical Quarterly

Chemical & Pharmaceutical Bulletin

Journal of the Chinese Chemical Society

Anti-Corrosion Methods and Materials

Journal of the American Chemical Society

Accounts of Chemical Research

Chemistry of Natural Compounds

Doklady Chemistry
Related Literature
Flue gas CO2 mineralization using thermally activated serpentine: from single- to double-step carbonation
Mischa Werner, Subrahmaniam Hariharan, Marco Mazzotti
DOI: 10.1039/C4CP02786H
Specific features of the electronic structure of a novel ternary Tl3PbI5 optoelectronic material
I. V. Kityk, N. M. Denysyuk, O. Y. Khyzhun, S. I. Levkovets, O. V. Parasyuk, A. O. Fedorchuk, G. L. Myronchuk
DOI: 10.1039/C4CP00591K
Water oxidation energy diagrams for photosystem II for different protonation states, and the effect of removing calcium
DOI: 10.1039/C3CP55329A
Excess entropy scaling for the segmental and global dynamics of polyethylene melts‡
Evangelos Voyiatzis, Florian Müller-Plathe, Michael C. Böhm
DOI: 10.1039/C4CP03559C
Photocatalytic performance of TiO2–zeolite templated carbon composites in organic contaminant degradation
Metta Chareonpanich, Khanin Nueangnoraj, Hirotomo Nishihara, Takashi Kyotani
DOI: 10.1039/C4CP03897E
Photoconversion of 6,13-α-diketopentacene in the crystalline phase
Katsuki Tanaka, Mariko Oe
DOI: 10.1039/C4CP01607F
Oxygen release technique as a method for the determination of “δ–pO2–T” diagrams for MIEC oxides
Ilya Starkov, Sergey Bychkov, Alexander Matvienko, Alexander Nemudry
DOI: 10.1039/C3CP52143E
Deep oxidation of 1,2-dichlorobenzene over Ti-doped iron oxide
Xiaodong Ma, Xueyue Suo, Huiqin Cao, Jie Guo, Lu Lv, Hongwen Sun, Meihua Zheng
DOI: 10.1039/C4CP00979G
You might also like
What is Ethyl 3-cyclohexylpropanoate (CAS: 10094-36-7)?
Ethyl 3-cyclohexylpropanoate is a clear, colorless to light yellow liquid with a...
How should waste containing 2-(Hydroxymethyl)-5-(methoxycarbonyl)-6-methyl-4-(2-nitrophenyl)nicotinic acid (CAS: 34783-31-8) be handled?
Waste containing 2-(Hydroxymethyl)-5-(methoxycarbonyl)-6-methyl-4-(2-nitrophenyl...
How should waste containing 2,4,6-Tris(pentafluoroethyl)-1,3,5-triazine (CAS: 858-46-8) be handled?
Waste containing 2,4,6-Tris(pentafluoroethyl)-1,3,5-triazine (CAS: 858-46-8) sho...
What precautions should be taken when handling Chloroac-nle-oh (CAS: 56787-36-1)?
When handling Chloroac-nle-oh (CAS: 56787-36-1), it is essential to wear appropr...
What industries use Ethyl 6-phenylimidazo[2,1-b][1,3]thiazole-3-carboxylate (CAS: 752244-05-6)?
Ethyl 6-phenylimidazo[2,1-b][1,3]thiazole-3-carboxylate is primarily used in the...
Are there alternatives to alpha-(2-Bromophenyl)benzylamine (CAS: 55095-15-3) in synthesis?
Alternatives to alpha-(2-Bromophenyl)benzylamine (CAS: 55095-15-3) in synthesis ...
How should waste containing 2-Chloro-5-methoxypyridine (CAS: 139585-48-1) be handled?
Waste containing 2-Chloro-5-methoxypyridine (CAS: 139585-48-1) should be managed...
What industries use 1-(4-Methoxyphenyl)-2,5-dimethyl-1H-pyrrole (CAS: 5044-27-9)?
1-(4-Methoxyphenyl)-2,5-dimethyl-1H-pyrrole (CAS: 5044-27-9) is used in various ...
Are there alternatives to 3-Bromo-5-(N-Boc)aminomethylisoxazole (CAS: 903131-45-3) in synthesis?
There are alternative reagents and compounds that can be used in the synthesis o...
What is Tungsten(IV) oxide (CAS: 12036-22-5)?
Tungsten(IV) oxide, also known as tungsten dioxide, is a chemical compound with ...




![3-[(4-Nitrobenzyl)oxy]-3-oxopropanoic Acid structure 3-[(4-Nitrobenzyl)oxy]-3-oxopropanoic Acid structure](https://static.chemtradehub.com/structs/773/77359-11-6-0d04.webp)
