A study of the OH-initiated oxidation of chlorinated ethenes in the gas phase
Literature Information
Carlos E. Canosa-Mas, Terry J. Dillon, Howard Sidebottom, Katherine C. Thompson, Richard P. Wayne
Rate constants for the reaction of OH radicals with trans-1,2-dichloroethene and 1,1-dichloroethene have been determined at a pressure of 1.6 Torr and at T = 298 ± 2 K using the discharge-flow technique. The same method was used to study for the first time the kinetics of the reactions of atomic Cl with trans-1,2-dichloroethene and with 1,1-dichloroethene at low pressure. The values obtained for the rate constants for the Cl-atom reactions are significantly lower than those published previously, which refer to atmospheric pressure. The rate coefficients are therefore likely to be strongly pressure dependent over the range 1.6–760 Torr. The value obtained at low pressure may be considered as the upper limit of the rate constant for the abstraction channel. The kinetic data obtained are summarised below. The release of atomic chlorine following the reaction of OH radicals with trans-1,2-dichloroethene, 1,1-dichloroethene and vinyl chloride has been observed by a direct method for the first time. The reaction of trans-1,2-dichloroethene with OH radicals gives a yield of Cl atoms that is essentially unity. The yield is independent of the presence of molecular oxygen, suggesting that Cl is released promptly after the addition of OH. Some release of Cl following the reaction of OH with 1,1-dichloroethene occurs in the absence of oxygen, although the release is enhanced by the presence of NO2 in the system. The dominant channel leading to the formation of Cl appears not to be the initial reaction with OH, but rather the decomposition of an alkoxy radical that is formed in a secondary process. The presence of molecular oxygen increases the yield of Cl atoms, probably as a result of increased formation of the alkoxy radical. The lower limit of the yield in the absence of O2 and NO2 is estimated to be 0.03; the corresponding limit when O2 is present is 0.05. Roughly 0.09 Cl atoms are released from vinyl chloride for each OH radical consumed. The release is due to the initial reaction of OH radicals, and the yield appears to correspond to the branching ratio for addition of OH to the more substituted end of the carbon–carbon double bond. FTIR spectroscopic studies were made of the products of reaction of Cl with 2-chloroethanol in the presence of O2. This reaction provides a mimic of the reaction of OH with vinyl chloride in that the same peroxy radical species, CH2(OH)CHClO2, is formed. The only organic products observed are formyl chloride and chloroacetaldehyde. The formyl chloride results from the abstraction of an H atom from the carbon atom bearing the Cl substituent. Formaldehyde formed in the system is photolysed to produce CO, an observed product. Chloroacetaldehyde is formed following the abstraction of a hydrogen from the carbon atom bearing the OH group. The oxidation of vinyl chloride by OH in the atmosphere proceeds ia the formation of CH2(OH)CH2ClO2. In the absence of NOx, the peroxy radical reacts with RO2 to yield the corresponding alkoxy radical. This alkoxy radical appears to decompose in exactly the same way as it does when it has been formed by the reaction of CH2(OH)CH2ClO2 with NO.
Related Literature
Coverage dependent structures of oligopyridine adlayers on (111) oriented Ag films
Matthias Roos, Harry E. Hoster, Achim Breitruck, R. Jürgen Behm
DOI: 10.1039/B708578H
Slice imaging of the photodissociation of acetaldehyde at 248 nm. Evidence of a roaming mechanism
L. Rubio-Lago, G. A. Amaral, A. Arregui, J. G. Izquierdo, F. Wang, L. Bañares
DOI: 10.1039/B708310F
Physical properties of soft repulsive particle fluids
D. M. Heyes, A. C. Brańka
DOI: 10.1039/B709053F
Solute–solvent interactions in imidazolium camphorsulfonate ionic liquids
Kaoru Nobuoka, Satoshi Kitaoka, Masashi Iio, Thomas Harran, Yuichi Ishikawa
DOI: 10.1039/B709407H
Porphyrin linked poly(pyridyl)-based conjugates as artificial photosynthetic reaction centre models
DOI: 10.1039/B708166A
Small angle X-ray scattering measurements probe water nanodroplet evolution under highly non-equilibrium conditions
Barbara E. Wyslouzil, Gerald Wilemski, Reinhard Strey, Soenke Seifert, Randall E. Winans
DOI: 10.1039/B709363B
On the position of the potential wall in DFT temporary anion calculations
Nick Sablon, Frank De Proft, Paul Geerlings, David J. Tozer
DOI: 10.1039/B711428A
You might also like
What is Ethyl 3-cyclohexylpropanoate (CAS: 10094-36-7)?
Ethyl 3-cyclohexylpropanoate is a clear, colorless to light yellow liquid with a...
How should waste containing 2-(Hydroxymethyl)-5-(methoxycarbonyl)-6-methyl-4-(2-nitrophenyl)nicotinic acid (CAS: 34783-31-8) be handled?
Waste containing 2-(Hydroxymethyl)-5-(methoxycarbonyl)-6-methyl-4-(2-nitrophenyl...
How should waste containing 2,4,6-Tris(pentafluoroethyl)-1,3,5-triazine (CAS: 858-46-8) be handled?
Waste containing 2,4,6-Tris(pentafluoroethyl)-1,3,5-triazine (CAS: 858-46-8) sho...
What precautions should be taken when handling Chloroac-nle-oh (CAS: 56787-36-1)?
When handling Chloroac-nle-oh (CAS: 56787-36-1), it is essential to wear appropr...
What industries use Ethyl 6-phenylimidazo[2,1-b][1,3]thiazole-3-carboxylate (CAS: 752244-05-6)?
Ethyl 6-phenylimidazo[2,1-b][1,3]thiazole-3-carboxylate is primarily used in the...
Are there alternatives to alpha-(2-Bromophenyl)benzylamine (CAS: 55095-15-3) in synthesis?
Alternatives to alpha-(2-Bromophenyl)benzylamine (CAS: 55095-15-3) in synthesis ...
How should waste containing 2-Chloro-5-methoxypyridine (CAS: 139585-48-1) be handled?
Waste containing 2-Chloro-5-methoxypyridine (CAS: 139585-48-1) should be managed...
What industries use 1-(4-Methoxyphenyl)-2,5-dimethyl-1H-pyrrole (CAS: 5044-27-9)?
1-(4-Methoxyphenyl)-2,5-dimethyl-1H-pyrrole (CAS: 5044-27-9) is used in various ...
Are there alternatives to 3-Bromo-5-(N-Boc)aminomethylisoxazole (CAS: 903131-45-3) in synthesis?
There are alternative reagents and compounds that can be used in the synthesis o...
What is Tungsten(IV) oxide (CAS: 12036-22-5)?
Tungsten(IV) oxide, also known as tungsten dioxide, is a chemical compound with ...
Source Journal
Physical Chemistry Chemical Physics

Physical Chemistry Chemical Physics (PCCP) is an international journal co-owned by 19 physical chemistry and physics societies from around the world. This journal publishes original, cutting-edge research in physical chemistry, chemical physics and biophysical chemistry. To be suitable for publication in PCCP, articles must include significant innovation and/or insight into physical chemistry; this is the most important criterion that reviewers and Editors will judge against when evaluating submissions. The journal has a broad scope and welcomes contributions spanning experiment, theory, computation and data science. Topical coverage includes spectroscopy, dynamics, kinetics, statistical mechanics, thermodynamics, electrochemistry, catalysis, surface science, quantum mechanics, quantum computing and machine learning. Interdisciplinary research areas such as polymers and soft matter, materials, nanoscience, energy, surfaces/interfaces, and biophysical chemistry are welcomed if they demonstrate significant innovation and/or insight into physical chemistry. Joined experimental/theoretical studies are particularly appreciated when complementary and based on up-to-date approaches.










![1-(Hexopyranosyloxy)-4a,5-dihydroxy-7-methyl-1,4a,5,6,7,7a-hexahydrocyclopenta[c]pyran-7-yl 3-phenylacrylate structure 1-(Hexopyranosyloxy)-4a,5-dihydroxy-7-methyl-1,4a,5,6,7,7a-hexahydrocyclopenta[c]pyran-7-yl 3-phenylacrylate structure](https://static.chemtradehub.com/structs/192/19210-12-9-ecae.webp)


![2-Bromodibenzo[b,d]furan structure 2-Bromodibenzo[b,d]furan structure](https://static.chemtradehub.com/structs/86-/86-76-0-1814.webp)
