Production of HO2 and OH radicals from near-UV irradiated airborne TiO2 nanoparticles
Literature Information
D. R. Moon, M. T. Baeza-Romero
The production of gas-phase hydroperoxyl radicals, HO2, is observed directly from sub-micron airborne TiO2 nanoparticles irradiated by 300–400 nm radiation. The rate of HO2 production as a function of O2 pressure follows Langmuir isotherm behaviour suggesting O2 is involved in the production of HO2 following its adsorption onto the surface of the TiO2 aerosol. Reduction of adsorbed O2 by photogenerated electrons is likely to be the initial step followed by reaction with a proton produced via oxidation of adsorbed water with a photogenerated hole. The rate of HO2 production decreased significantly over the range of relative humidities between 8.7 and 36.9%, suggesting competitive adsorption of water vapour inhibits HO2 production. From the data, the adsorption equilibrium constants were calculated to be: KO2 = 0.27 ± 0.02 Pa−1 and KH2O = 2.16 ± 0.12 Pa−1 for RH = 8.7%, decreasing to KO2 = 0.18 ± 0.01 Pa−1 and KH2O = 1.33 ± 0.04 Pa−1 at RH = 22.1%. The increased coverage of H2O onto the TiO2 aerosol surface may inhibit HO2 production by decreasing the effective surface area of the TiO2 particle and lowering the binding energy of O2 on the aerosol surface, hence shortening its desorption lifetime. The maximum yield (i.e. when [O2] is projected to atmospherically relevant levels) for production of gas-phase HO2, normalised for surface area and light intensity, was found to be at a RH of 8.7% for the 80% anatase and 20% rutile formulation of TiO2 used here. This yield decreased to as the RH was increased to 22.1%. Using this value, the rate of production of HO2 from TiO2 surfaces under atmospheric conditions was estimated to be in the range 5 × 104–1 × 106 molecule cm−3 s−1 using observed surface areas of mineral dust at Cape Verde, and assuming a TiO2 fraction of 4.5%. For the largest loadings of dust in the troposphere, the rate of this novel heterogeneous production mechanism begins to approach that of HO2 production from the gas-phase reaction of OH with CO in unpolluted regions. The production of gas-phase OH radicals could only be observed conclusively at high aerosol surface areas, and was attributed to the decomposition of H2O2 at the surface by photogenerated electrons.
Recommended Journals

New Journal of Chemistry

Russian Journal of Coordination Chemistry

Current Opinion in Solid State & Materials Science

Drug Discovery Today

Russian Journal of General Chemistry

Nature Medicine

Russian Journal of Bioorganic Chemistry

Journal of Saudi Chemical Society

Russian Chemical Bulletin

Chemical Communications
Related Literature
Theoretical study of alkoxyl radical decomposition reactions: structure–activity relationships
Raphaël Méreau, Marie-Thérèse Rayez, Françoise Caralp, Jean-Claude Rayez
DOI: 10.1039/B003993O
The weakly bound g round state of the LiHe2 triatomic system
I. Baccarelli, G. Delgado-Barrio, F. A. Gianturco, T. González-Lezana, S. Miret-Artes, P. Villarreal
DOI: 10.1039/B002415P
Photophysics and photochemistry of 2,6-distyrylpyridine and some heteroanalogues
L. Giglio, U. Mazzucato, G. Musumarra, A. Spalletti
DOI: 10.1039/B004141F
The kinetics of phase transitions in underpotentially deposited Cu adlayers on Au(111)
X. H. Xia, L. Nagle, R. Schuster, O. M. Magnussen, R. J. Behm
DOI: 10.1039/B003585H
Influence of the boundaries in the impedance of porous film electrodes
DOI: 10.1039/B001708F
Adsorption of CO2 on FSM-type mesoporous silicas
Masahiro Katoh, Keiichi Sakamoto, Mituo Kamiyamane, Tahei Tomida
DOI: 10.1039/B004505P
You might also like
What precautions should be taken when handling 4-Methyl-6-(trifluoromethyl)quinoline (CAS: 40716-16-3)?
When handling 4-Methyl-6-(trifluoromethyl)quinoline (CAS: 40716-16-3), safety go...
What is 4-(3,5-Difluorophenyl)aniline (CAS: 405058-00-6)?
4-(3,5-Difluorophenyl)aniline is an aromatic organic compound with the CAS numbe...
How is 5-{[4-(Trifluoromethyl)phenyl]sulfanyl}-1,2,3-thiadiazole-4-carboxylic acid (CAS: 338982-07-3) typically synthesized?
5-{[4-(Trifluoromethyl)phenyl]sulfanyl}-1,2,3-thiadiazole-4-carboxylic acid can ...
What is the market or research trend for 4-Benzylaniline hydrochloride (CAS: 6317-57-3)?
The market for 4-Benzylaniline hydrochloride (CAS: 6317-57-3) is steadily growin...
Is [3-(Diethylsulfamoyl)phenyl]boronic acid (CAS: 871329-58-7) safe?
[3-(Diethylsulfamoyl)phenyl]boronic acid is generally considered safe when handl...
What are the main uses of 3-Bromo-2,5-dimethoxyaniline (CAS: 115929-62-9)?
3-Bromo-2,5-dimethoxyaniline is mainly used in the pharmaceutical and chemical i...
What regulatory guidelines apply to N-Methyl-1-(5-methyl-1H-indol-3-yl)methanamine (CAS: 915922-67-7)?
N-Methyl-1-(5-methyl-1H-indol-3-yl)methanamine (CAS: 915922-67-7) is subject to ...
What industries use Carbamic acid, N-[(5S)-5,6-diamino-6-oxohexyl]-, 1,1-dimethylethyl ester (CAS: 24828-96-4)?
This compound is primarily used in the pharmaceutical industry for the synthesis...
How should 2-Methyl-2-propanyl [(1S,3R)-3-aminocyclohexyl]carbamate (CAS: 1298101-47-9) be stored?
2-Methyl-2-propanyl [(1S,3R)-3-aminocyclohexyl]carbamate (CAS: 1298101-47-9) sho...
What industries use Ethyl 2-bromo-4,4,4-trifluorobutanoate (CAS: 367-33-9)?
Ethyl 2-bromo-4,4,4-trifluorobutanoate (CAS: 367-33-9) is utilized in the pharma...
Source Journal
Physical Chemistry Chemical Physics

Physical Chemistry Chemical Physics (PCCP) is an international journal co-owned by 19 physical chemistry and physics societies from around the world. This journal publishes original, cutting-edge research in physical chemistry, chemical physics and biophysical chemistry. To be suitable for publication in PCCP, articles must include significant innovation and/or insight into physical chemistry; this is the most important criterion that reviewers and Editors will judge against when evaluating submissions. The journal has a broad scope and welcomes contributions spanning experiment, theory, computation and data science. Topical coverage includes spectroscopy, dynamics, kinetics, statistical mechanics, thermodynamics, electrochemistry, catalysis, surface science, quantum mechanics, quantum computing and machine learning. Interdisciplinary research areas such as polymers and soft matter, materials, nanoscience, energy, surfaces/interfaces, and biophysical chemistry are welcomed if they demonstrate significant innovation and/or insight into physical chemistry. Joined experimental/theoretical studies are particularly appreciated when complementary and based on up-to-date approaches.

phosphoryl}methyl 4-methylbenzenesulfonate structure {[3-(Hexadecyloxy)propoxy](hydroxy)phosphoryl}methyl 4-methylbenzenesulfonate structure](https://static.chemtradehub.com/structs/864/864068-45-1-ba7c.webp)


![(2E)-3-(3-Chlorophenyl)-N-{2-[4-(methylsulfonyl)-1-piperazinyl]-2-oxoethyl}acrylamide structure (2E)-3-(3-Chlorophenyl)-N-{2-[4-(methylsulfonyl)-1-piperazinyl]-2-oxoethyl}acrylamide structure](https://static.chemtradehub.com/structs/250/2505001-54-5-c1e9.webp)